A piano tuner sits down at a grand that has just been tuned to the mathematical ideal. Every octave is exactly 2:1, and every note sits dead center on an electronic tuner. It is, by the numbers, perfect. Then they play a few octaves up in the treble, wince, and begin to move the notes away from perfect. When they finish, the piano is wrong by the tuner's measure and right by every ear in the room.
This isn't a tuner's superstition or an old craft habit. It's a small, true fact about how real strings behave, and it quietly changes what "in tune" means.
The string you learned about isn't the string you have
In school we learn that a vibrating string makes a fundamental pitch plus a stack of overtones at whole-number multiples: 2×, 3×, 4× the fundamental. That's the ideal string, perfectly flexible and infinitely thin.
A piano string is steel wire, held under very high tension, and it has stiffness. Stiffness acts like a tiny extra spring pushing the string back toward straight, and it matters most for the higher overtones, which bend the string into tighter wiggles. The result is called inharmonicity: the overtones come out slightly sharper than the clean whole-number multiples. The higher the overtone, the more it overshoots.
So the second partial of a piano note isn't quite twice the fundamental. It's a little above. The third is further off, and so on. The sound still reads as a single pitched note, but its internal skeleton is subtly stretched.
Short, thick strings show this more. That's why small upright pianos and the very top and bottom of any piano are the most affected.
Why that wrecks a "perfect" octave
Here is the part that matters for your ears. When two notes an octave apart are played together, you don't only hear the two fundamentals. You hear their overtones interacting. The upper note's fundamental is supposed to line up with the lower note's second partial.
On a piano, that second partial has been pushed sharp by inharmonicity. If the tuner sets the upper note to exactly twice the lower fundamental, the two sounds no longer match. The upper note now sits a little below the lower note's second partial, and the two frequencies slowly interfere. You hear that as beating, a faint wobble in the sound, and the octave feels thin, sour, or a touch flat.
To make the octave sound pure, the tuner raises the upper note until it matches the partial it's actually being compared with. That is stretch tuning: octaves are made slightly wider than 2:1. Do it across the whole keyboard and the treble drifts progressively sharp of the theoretical scale, while the bass drifts progressively flat.
The tuner isn't giving up on accuracy. They're tuning to what the instrument actually sounds like instead of what the textbook says it should.
Do people really prefer the stretched version?
They do, and this was studied long ago. In the late 1930s the acoustician O. L. Railsback measured the tuning of real, professionally tuned pianos and found that the tuned notes consistently departed from the strict equal-tempered values, in the same smooth direction: flatter in the bass, sharper in the treble. That pattern is now known as the Railsback curve.
The interesting thing is that tuners weren't reading a chart. They were using their ears to find the smoothest-sounding result, and the ears converged on the stretch that inharmonicity predicts. Our hearing treats a stretched piano as being in tune because it's tuned to the instrument's real partials.
A related effect is often cited with it: listeners tend to judge very high pitches as flat if they're set to exact ratios, and sometimes prefer slightly wide octaves even with pure tones. The exact reasons are still discussed, so it's safer to say the physics of the strings is the main driver on a piano, and perception may add a little on top.
What this does to your tuner app
An electronic tuner measures one thing: the frequency it hears, compared to a reference grid, reported in cents. On a piano, that reading can be quietly misleading.
Play A4 and it may read very close to center. Play A6 in a well-tuned piano and the display may show it noticeably sharp. Play something deep in the bass and it may read flat. Nothing is broken. You're watching stretch tuning in real time.
If you "correct" those notes to zero cents, you'll make a good piano worse. Every octave will start to beat, and the instrument will sound slightly dull or out of focus, even though every needle looks perfect.
This also explains an experience many people have: a keyboard or software instrument, which has no inharmonicity at all, tunes perfectly to a meter, yet a real piano that's measurably "off" sounds warmer and more alive next to it.
Tuning guitars and violins is different. Their strings are far more flexible, so inharmonicity is small and a tuner works fine. But you can sometimes hear a mild version of the same thing in the highest positions.
Your next moves
- Measure the stretch yourself. If you have access to a piano, play A3, A4, A5 and A6 one at a time with your tuner open. Write down the cent reading for each. If the piano has been well tuned, you'll likely see a gentle climb into the sharp side as you go up.
- Listen for beating in an octave. Play C4 and C5 together and hold them. Listen for a slow wavering in the sound. A perfectly pure octave is steady. Now do the same with a fifth, and compare what "steady" feels like.
- Don't chase zero on a piano. If you play a piano that isn't yours, resist the urge to judge it by the needle. Check the middle octave (around A4) against your tuner, then trust your ears for the rest.
- Tune everything else to the piano, not the other way around. If you're playing with a piano, tune your guitar or violin to its A and ignore any small disagreement elsewhere on the keyboard. Moving a piano isn't an option, and it's the instrument that can't adjust on the fly.
- Test a keyboard against a piano. Play the same high octave on a digital keyboard and an acoustic piano. Notice which sounds "cleaner" and which sounds "warmer," and check each with your tuner. It's an easy way to hear the difference between mathematically perfect and musically true.
The quiet lesson underneath
There's something oddly human in this. The tuner who nudges every note off the grid is closer to the truth than the meter that says everything is fine. A number can be exact and still be wrong for the thing it's measuring.
A tuner, whether electronic or a person with a lever and a good pair of ears, is a tool that has to serve the sound, not replace your judgment of it. That's the reason we like having a clear, precise reading of pitch in Maestro. It's there to show you exactly where a note sits in cents, so you can see the piano's stretch for what it is and make a considered choice. Precision is most useful when you know what it's telling you, and when to listen past it. If that sounds like your kind of practice, you can find Maestro at https://maestro.lumenlabs.works.